Lil' Factory in the woods

Call the Order Desk: 803-732-0937 Fax: 803-732-9921 1212 O'Sheal Road Irmo, SC 29063 E-Mail

Pyrotect Helmet Sizing

Home
Free Freight Policy
Clearance Sale
Helmet Flea Market
Helmets
Helmet Accessories
Head and Neck Device
Driver Suits
Underwear
AlpineStars
Driver Cooling
Gloves
Shoes
Corner Worker and Crewwear
Belts and Harnesses
Window Nets
Race Car
Gauges and Panels
Tire Gauges
Oils and Chemicals
Pit Gear
Karting and Jr Dragster
Used Car Lot

Over Half of Trackside Tim's Staff have Experience as Drivers and Officials!

Trackside Tim's Strives to use American Material Whenever Possible!

Trackside Tim's 2018
Designed by TurboJohn 2018

 
Home : Helmets : Racer Series

Measurement
Measuring the head is a starting point for the entire sizing procedure. Due to varying shapes, heads that are apparently the same size when measured by a tape may not necessarily fit the same size helmet.The circumference of the head should be measured at a point approximately one inch above the eyebrows in front and at a point in the back of the head that results in the largest possible measurement. Take several measurements to make sure you have the largest one. This is the size to compare on the chart below.

NOTE: If you have facial hair (beard) or an unusually thick head of hair, you may want to consider ordering 1 size up from what is shown on the sizing charts if you are near the top of your size range.